Electric Water Combi Deck - nylon waist (elastic & drawstring) and 3mm neoprene deck, with braces (no pocket)

Spray decks are intended to be tightly fitting - you don't want them peeling off when the going gets tough. This can also make them firmer to put on! If you have a very large cockpit (if greater than a metre long please choose separate listing for long decks), you will have difficulty fitting your deck unless you have very long arms!

For a well-fitted neoprene spraydeck it is best to get one made specifically for your cockpit - this means tracing out a template, measuring yourself and locating where your seat back sits so the waist tube goes in the right place. Electric Water already have templates for some of the most popular makes.

Each "Custom" deck is lovingly made in Australia, using secret EW techniques developed over the years that have provided real paddlers with the deck which will see them through the challenge of the water they dare to do. When you see someone with an EW deck, you know they are very serious about their paddling.

The Combi spraydeck is crafted from the 3mm neoprene (same as used in the standard deck) but with a generous sized proofed nylon waist with drawstring closure (also elasticised) and braces. This deck does not fit closely around your waist, so it is a good warmer weather deck. This also means it is not watertight when you roll!

Waist - measured at combing level the waist tube fits waist up to 124cm, as the deck will go over the PFD - so at chest level including the PFD the tube is 140cm.

What makes EW decks so different?

• EW decks are made with specially ordered custom fabrics to meet our standards for comfort and abrasion resistance with various neoprene grades to meet the performance requirements. EW decks will stand up to the task season after season (they do not use sub-standard materials and do not take short cuts when making of the EW deck) We are paddlers ourselves and know what is needed to make good gear.
• EW gear is manufactured with materials to provide stability, strength, durability and protection from wear and tear.  The seams are not stitched - so no holes for water to seep through, in fact, they are sealed in more ways than one and that is one of the ways we ensure the decks will not come apart.
• If you find that you are in that situation when you need to "bail" the release strap is big and easy to find and very securely joined. You can trust it to not fail when your life depends on it! The EW team use them themselves.
• They are not a mass produced effort with a "one size fits all" mentality, if your seat position is forward or back in the boat don't spend your energy fighting the deck ! tell us where you sit and we will get the tube in the right place for you.
• Electric Water custom make decks to fit your boat.  We want you safe and secure so we make the deck to suit your boat.  They may take a little longer to get but they are definitely worth the wait. 

For a Custom-Fitted Deck:

1. Trace a template on a piece of not-too-thick plastic. See Youtube video below. Make sure you trace around the outside of the cockpit combing.
2. Mark the position of the backrest on the template
3. Label the template with your name, kayak make & model, and whether it is fibreglass or plastic
4. Measure your **Waist** - position the tape at the height level to where you sit in your kayak level with the top of the combing - this will possibly be a different point than your actual waist - write the waist measurement on the template
5. Post your template to us at East Coast Kayaking, PO Box 7522, Beaumaris VIC 3193

On average it will take approx. 4 weeks (after receipt of template if required) to create your spraydeck.
Orders will be shipped direct from the manufacturer, so if you have ordered this item as part of a more extensive order the shipping cost will reflect that there will be two parcels - one from us and one for your deck.