The Rod Holder II is robust, versatile, and value for money, it will hold your rod, you choose which position.
- Rotating collar helps reduce 'strike-theft'
- Rear gimble lock reduces rod rotation for compatible rods; lift to slide rods through
- Fully adjustable 360° around, over 90° vertical
- Easy access to reel when in position
- Square-tooth adjustable tilt stops rotational slipping.
The Rod Holder II is available either as a kit complete with a StarPort, or as a Rod Holder by itself.
For spinning reels, bait casting reels, boat reels, fly reels. Allows you to fit your Rod Holder to any StarPort, SidePort, RailMount or RIBPort.
Kit Contains:
- 1x Rod Holder II - black
- 1x StarPort™ - black
- 1x surface mount collar
- 1x weather-tight gasket & cover
- 2x 12-gauge 32 mm self-tapping screws
- 2x M6 x 35mm machine screws, washers & nuts
- Installation instructions
INSTALLATION: StarPort™
- The StarPort™ can be mounted on the surface using the surface mount collar supplied or it can be recessed into any horizontal or vertical surface.
- Ensure you have adequate clearance behind the surface for screw and/or bolt penetration. and that no cabling, plumbing or rigging will be adversely affected.
- We recommend the use of a suitable sealant between the collar and the deck.
- Drill holes using the template or surface mount collar as a guide.
- SURFACE MOUNT: Stack collar, gasket and StarPort in place, then fit bolts or screws.
- RECESS MOUNT: Fit gasket and StarPort in place, then fit bolts or screws.
- Tighten nuts or screwheads to a firm tension.
Maintenance
When finished fishing for the day, remove from StarPort and stow in dry place, do not store wet.
NOTE: We strongly recommend that you tether your fishing rod to the boat while in use. Loss of fishing rods while using the RAILBLAZA Rod Holder is not covered by the RAILBLAZA warranty.